4G Installation and Configuration “Hardware”
The course is designed for “installers” this course covers the major aspects of deploying a 4G fingerprint solution as well as covering all the communication protocols, intended functionality and installation preparation and planning. For standalone deployments the installer will learn how to administer the product via the front panel of the V-Station 4G.
At the end of this course you should be able to:
- Define and discuss basics of Biometrics
- Install systems hardware
- Operating V-Station from a front Panel
After completing this course, you will receive an online certificate of completion to your email address
REGISTER TODAY and receive a FREE 15 minutes training session on
Enrollement best practices for 4G
The course consists of six (6) modules, each addressing separate topic areas:
- Introduction
L-1 Solutions - Planning the installation
Recommended steps for a successful installation
Unpack equipment – Important Notes - Hardware installation
Wall mounting schemes
Installing a mounting plate
Installation hardware
Attach device to mounting plate
Connect device to earth ground
Connect device to power source
Connect device to network
Aux port
Install ferrite core - System start-up procedures
System start-up overview
Device configuration check - Single door access control
Relay configuration
Request to exit configuration
Door contact configuration - Operating the V-station 4G™ from the front panel
Accessing administrator mode
System information menu
Security Menu
Communication menu
Multimedia menu
Template menu
Keypad verification
Keypad identification
Keypad identification on 50K products
REGISTER TODAY and receive a FREE 15 minutes training session on
Enrollement best practices for 4G
